Pentax IQ ZOOM 115M Operating Manual page 53

In any case, however, shipping charges and cus¬
toms clearance fees are to be borne by the sender.
To prove the date of your purchase when re¬
quired, please keep the receipts or bills covering
the purchase of your equipment for at least a year.
Before sending your equipment for servicing,
please make sure that you are sending it to the
manufacture's authorized representatives or their
approved repair shops, unless you are sending it
directly to the manufacturer. Always obtain a
quotation for the service charge, and only after
you accept the quoted service charge, instruct the
service station to proceed with the servicing.
The local warranty policies available from Pentax
distributors in some countries can supersede this
warranty policy. Therefore, we recommend that
you review the warranty card supplied with your
product at the time of purchase, or contact the
PENTAX distributor in your country for more in¬
formation and to receive a copy of the warranty
policy.
STATEMENT OF FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following tw'o conditions : (1) This device may not
cause harmful interference, and (2) this device must accept any inter¬
ference received, including interference that may cause undesired op
e rat ion.
Changes or modifications not approved by the party responsible for
compliance could void the user's authority to o^rate the equipment
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment gen¬
erates, uses and can radiate radio frequency energy and, if not in¬
stalled and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi¬
sion reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one
or more of the following measures :
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
49