AEG LF62R840 User Manual page 24

24 www.aeg.com
12.8 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
1. The appliance detects the load in the
first 30 seconds: the indicator
the time dots flash, the drum rotates
shortly.
2. At the end of the load detection, the
indicator
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pauze - Départ/Pause
button to start the programme again. The
ProSense phase can be repeated up to
three times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
The ProSense is not
available with some
programmes, such as Wol/
Zijde - Laine/Soie,
programmes with short
cycles and without washing
phase.
goes off and the time
12.9 Interrupting a
programme and changing the
options
When the programme is running, you
can change only some options:
1. Touch the button Start/Pauze -
Départ/Pause.
and
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the button Start/Pauze -
Départ/Pause again.
The washing programme continues.
12.10 Cancelling a running
programme
1. Press the button Aan /Uit - Marche/
Arrêt to cancel the programme and to
deactivate the appliance.
2. Press the button Aan /Uit - Marche/
Arrêt again to activate the appliance.
Now, you can set a new washing
programme.
If the ProSense phase is
already carried out and the
water filling is already
started, the new programme
starts without repeating the
ProSense phase. The water
and the detergent are not
drained out in order to avoid
waste. The display shows
the maximum duration of the
programme, updating it
about 20 minutes after the
starting of the new
programme.
12.11 Opening the door -
Adding garments
While a programme or the delay start
operates, the appliance door is locked.
If the temperature and level
of the water in the drum are
too high and/or the drum still
rotates you cannot open the
door.