Seiko EMMY WATCH 7T32B Manual page 11

TECHNICAL GUIDE Cal. 7T32B, 7T42B
@ Circuit block cover
* How to remove
1) Loosen the four screws and remove
them.
2) Release the click portion of the alarm
yoke. -
3) Release the three hooking portions of A i)
the circuit block cover by prying them ~ a =
up with the tip of a screwdriver as =
shown in the illustration at right.
* [Installing and lubricating
1) Set the hooking portion ©)
2) Check that the circuit block cover is
securely set to the guide tube {a} and
(b).
3) Set the hooking portions in the order
of and @ in the illustration,
4) Tighten the screw (c).
5) Hook the alarm yoke spring (d).
6) Tighten the other three screws.
7) Lubricate the click portion ofthe alarm
yoke.
@ Friction spring for second-counting
Slip the friction spring for second-
counting into the gap under the train
wheel bridge.
* Setting position
Circuit block
* How to instali
Set the guide holes (a ~ f in the illustration) of
the circuit block securely onto the corresponding
collars of the train wheel bridge.
10