Maintenance, Care & Cleaning - True T-12FG Installation Manual

MAINTENANCE, CARE & CLEANING
CLEANING THE CONDENSER COIL
When using electrical appliances, basic safety precautions should be followed, including the following:
REQUIRED TOOLS:
• Phillips Screwdriver
• Stiff Bristle Brush
• Adjustable Wrench
• Air Tank or CO 2 Tank
• Vacuum Cleaner
Step 1
Disconnect power to unit.
Step 2
SLIDE DOOR MODELS: (See Image 1)
Take off lower grill assembly by removing two (2)
screws in lower corners. (older models may have
snap lock tabs instead of screws).
Loosen screws holding the top pivot pins. Swing
grill up and remove frame hooks from pivot pins at
top of louver.
SWING DOOR MODELS: (See Image 2)
Take off lower grill assembly by removing four (4)
corner screws.
Step 3
Remove bolts anchoring compressor assembly
to frame rails and carefully slide out. (tube
connections are flexible)
Step 4
Clean off accumulated dirt from the condenser coil
and the fan with a stiff bristle brush.
Step 5
Lift cardboard cover above fan at plastic plugs and
carefully clean condenser coil and fan blades.
Step 6
INDOOR LOCATION:
After brushing condenser coil vacuum dirt from
coil, and interior floor.
16
16
MAINTENANCE, CARE & CLEANING
MAINTENANCE, CARE & CLEANING
............ www.truemfg.com ............
............ www.truemfg.com ............
True Food Service Equipment, Inc.
True Food Service Equipment, Inc.
OUTDOOR LOCATION:
(GDM-33, GDM-47, and GDM-49 only) After brush-
ing condenser coil blow CO 2 through condenser
from fin side to fan. (See Image 4.)
Step 7
Replace cardboard cover. Carefully slide compres-
sor assembly back into position and replace bolts.
Step 8
Reinstall louver assembly onto unit with appropri-
ate fastener and clips. Tighten all screws.
Step 9
Connect unit to power and check to see if compres-
sor is running.
Image 1. Slide Door Models
Image 3.
Image 4.
Image 2. Swing Door Models
16
16