Advertisement
Available languages
Available languages
LOCATION AND FUNCTION OF CONTROLS
Control and tuner sections
@® STEREO indicator
Kp TUNED (tuning) indicator
ip Dial scale and pointer
7B Function selectors and indicators
h® TUNING knob
panel cover
Push here to open the cover.
@ POWER switch
Depress to turn on the power. To turn off, press the switch again.
While the power is on, the dial pointer and the cassette compartment
are illuminated.
@ SPEAKERS selector
OFF: to cut off the speaker sound or to monitor through the head-
phones.
A: to drive speaker system A (connected to the SPEAKER A ter-
minals).
A+B: to drive both speaker system A and B. If only one speaker
system is connected
with the selector in this position, no sound
will be heard, because the A and B terminals are connected
in
series.
@ © (headphone) jack
Accepts any headphones.
For private listening, set the SPEAKERS
selector to OFF. The headphone volume can be adjusted with the
VOLUME
control.
© STEREO indicator
Lights up when an FM stereo program of sufficient signal strength is
tuned in with the FM MODE switch set to 0 STEREO (MUTING ON).
© TUNED (tuning) indicator
Lights up when a broadcasting signal is tuned in accurately.
@ Dial scale and pointer
VOLUME
control
Ti) ISS (interference suppress switch)
(bottom)
I
LOUDNESS switch
1¥) BALANCE
control
iK} BASS and TREBLE TONE controls
1 FM MODE switch
@ Function selectors and indicators
Select the desired program source. The indicator of the selector in
use illuminates.
TAPE: for playing back the built-in cassette deck or for using a micro-
phone.
PHONO: for record playing (connected to PHONO
inputs).
FM: for FM broadcasting programs received by the built-in tuner.
MW: for MW broadcasting programs received by the built-in tuner.
LW: for LW broadcasting programs received by the built-in tuner.
AUXITV: for auxiliary source programs (connected to AUX/TV inputs)
© TUNING knob
Turn to select the desired station.
@Q VOLUME control
Turn clockwise for more volume.
@ ISS (interference suppress switch) (bottom)
Used for MW or LW program recording. See page 10.
@ LOUDNESS switch
Normally keep this switch released (0
OFF). When listening to pro-
gram sources at a low volume, depress the switch (a ON).
The loudness control compensates
for the human
ear's reduced
response to very low frequency sound at low volume levels, and pro-
vides an apparently uniform response at these levels.
The effect on this control gradually decreases as the volume in-
creases.
® BALANCE control
Regulates the sound balance between right and left channels for op-
timum stereo effect. Clockwise rotation (to R) decreases the left-
channel sound, and vice versa.
.
Normally set the control to the center position.
® BASS and TREBLE TONE controls
Adjust the tone quality of the reproduced sound. Turn clockwise (to
+) for more bass or treble and counterclockwise (to —) for less.
Advertisement
