Table of Contents
Advertisement
Combustible materials.
injury or death. Hot generator set can ignite debris in
compartment. Keep the compartment and generator
set clean and free of debris and combustible materials to
minimize possibility of fire. Do not block fuel/oil drain
opening in generator set mounting tray.
corresponding hole in the subfloor for drain opening if
subfloor is used.
Moving Parts
WARNING
Hazardous voltage.
Can cause severe injury or death.
Operate generator set only with all guards and
electrical enclosures in place.
WARNING
Rotating parts.
Can cause severe injury or death.
Do not operate generator set without all guards,
screens, and covers in place.
Tightening hardware. Flying projectiles can cause
severe injury or death. Retorque all crankshaft and
rotor hardware after servicing. Do not loosen crankshaft
hardware or rotor thrubolt when making adjustments or
servicing generator set. Rotate crankshaft manually in a
clockwise direction only. Turning crankshaft bolt or rotor
thrubolt counterclockwise can loosen hardware. Loose
hardware can cause hardware or pulley to release from
engine of generator set and can cause personal injury.
Servicing generator set when operating. Exposed
moving parts can cause severe injury or death.
Keep hands, feet, hair, clothing, and test leads away
from belts and pulleys when generator set is running.
Replace guards, screens, and covers before operating
generator set.
TP-5605 4/97
Fire can cause severe
Cut a
Moving rotor.
Notice
NOTICE
This generator set has been rewired from its
nameplate voltage to:
NOTICE
Voltage reconnection! Affix notice to generator set
after reconnecting to a voltage different than the
nameplate. Order voltage reconnection decal 246242
from authorized service distributors/dealers.
NOTICE
Hardware damage! Engine and generator set may use
both American Standard and metric hardware. Use the
correct size tools to prevent rounding of bolt heads and
nuts.
NOTICE
When replacing hardware, do not substitute with
inferior grade hardware.
available in different hardness ratings.
Standard hardware uses a series of markings and
metric hardware uses a numeric system to indicate
hardness. Check markings on bolt head and nuts for
identification.
NOTICE
Canadian installations only:
For standby service connect output of generator set to a
suitably rated transfer switch in accordance with
Canadian Electrical Code, Part 1.
NOTICE
This generator set does not comply with United
States Coast Guard (U.S.C.G.) requirements and
must not be used for marine applications. Use only
generator sets specified for marine use in marine
installations. U.S.C.G. Regulation 33CFR183 requires
a generator set to be ignition protected when used in a
gasoline-fueled environment.
Safety Precautions and Instructions V
246242
Screws and nuts are
American
Advertisement
Table of Contents
