Table of Contents
Advertisement
STANDARD TIGHTENING TORQUES
3
INTRODUCTION OF NECESSARY TOOLS
3
The following tools are needed when carrying out maintenance.
No.
Name of tool
1. Wrench Set
2. Tool Kit
3. Filter Wrench
4. Grease Pump
5. Grease Cartridge
If any of the above tools are broken, please order them from your distributor. When not using the tools, always put them in the
appropriate tool box.
D87E-2 D87P-2
Part No.
Width across flats - S
Open end wrench - 8x10 mm
Open end wrench - 12x14 mm
09000-30006
Open end wrench - 13x17 mm
Open end wrench - 19x22 mm
Open end wrench - 24x27 mm
Open end wrench - 30x33 mm
Open end wrench - 7/16x1/2
Open end wrench - 9/16x5/8
Open end wrench - 5/8x11/16
Open end wrench - 3/4x13/16
Open end wrench - 15/16x1
Screwdriver - 1/4 shank
Screwdriver - 3/8 shank
Ball peen hammer
276 820 R91
Pry bar - 9/16x16
Adjustable wrench
Center punch - 5/16x10
Chisel - 7/8x10
Pin punch - 3/16x10
Vise grip wrench
Slip joint plier
Diagonal (side) cutter
Tool box
DR02-535
Removal of filter cartridge
999 677 R91
For lubrication of machine
For type, see "USE OF FUEL, COOLANT AND LUBRICANTS" on page 3-7
Description
xS
1
2
MAINTENANCE
3-13
Advertisement
Table of Contents
