Control Panels - GE GFWN1000 Owner's Manual & Installation Instructions

About the washer features.
NOTE:Features may not be available on all washer models.
Cycle Signal
Use the SIGNALbutton to change Pressthe button until gou reach
the volume of the end of cgcle signal, the desired volume.
Prewash Ion some models)
Prewash is an extra wash before
the main wash. Use it for heavilg soiled
clothes or for clothes with a care label
that recommends prewashing before
washing. Be sure to add high-efficiencg
detergent, or the proper wash additive
to the prewash dispenser.
NOTE:When selecting prewash,
it is recommended to use powder
detergent in the main wash (detergent)
compartment.
Extra Rinse
Use an extra rinse when additional rinsing
is desired to remove excess dirt and
detergent from soiled loads.
Delay Start (on some models)
You can delag the start of a wash cgcle
for 10-18 hours, depending on the model.
Pressthe DELAYSTART button to choose
the number of hours gou want to delag
the start of the cgcle,then pressthe START
button. The machine will count down and
start automaticallg at the correct time.
NOTE:If you forget to fully closethe door,
a reminder signal will beep reminding you
to do so.
NOTE:If you open the door when the delay
is counting down, the machine will enter
the pause state. You must close the door
and press START again in order to restart
the countdown.
Lock
You can lock the controls to prevent ang
selections from being made. Or gou can
lock the controls after gou have started
a cgcle.
HOLD 3 SECSTO
LOCK & UNLOCK
CONTROL PANEL
Children cannot accidentally start
the washer by touching pads with
this option selected.
To lock the washer, press and hold
the DELAYSTART button for 3 seconds
(on some models use SIGNAL button).
To unlock the washer controls, press
and hold the DELAYSTART button for
3 seconds.
The control lock icon on the displag will
light up when it is on.
NOTE:The POWER button can still be
used when the machine is locked.
ii_iii_iiill _I i_ _ !_ ii_i_
MY CYCLE (on some models)
Tosave a favoritecgcle,set the desired
settingsfor wash cgcle,soillevel,spinspeed
and wash temp settingsand hold down the
MYCYCLE button for 3 seconds.A beep will
sound to indicatethe cgcle has been saved.
To use gour custom cgcle, press the
MY CYCLE button before washing a load.
To change the saved cgcle, set the desired
settings and hold down the MY CYCLE
button for 3 seconds.
NOTE: When using MY CYCLE, wash
options cannot be modified after the
cycle has been started.
NOTE:If you change wash options with
MY CYCLEbefore starting the cycle, the
MY CYCLElight will turn off and you will
be returned to the base cycle.
8
BASKET CLEAN
BasketClean is a cgcle that freshens up
the inside of gour washer. The cgcle uses
bleach or other available washing
machine cleaners and more water to
refresh gout washer. Use BasketClean
once everg month to reduce odor and
residue buildup inside the washer.
For more information on BasketClean,
refer to the Care and Cleaning section
on page 12.