Replacing the camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Place the camera and camera bracket in the slot on the retractable-camera
assembly and snap it in place.
2
Align the screw holes on the camera-assembly cover with the screw holes on the
retractable-camera assembly.
3
Replace the three screws (M3x5) that secure the camera-assembly cover to the
retractable-camera assembly.
4
Press the top of the retractable-camera assembly to retract the retractable
camera.
5
Route the camera cable through the routing guides on the display-assembly
base.
6
Place the retractable-camera assembly on the display-panel base.
7
Replace the two screws (M3x5) that secure the retractable-camera assembly to
the display-assembly base.
8
Connect the camera cable to the system board.
Post-requisites
1
Replace the
system-board
2
Replace the
back
3
Replace the stand.
computer. After working inside your computer, follow
After working inside your
shield.
cover.
computer. For more safety best
www.dell.com/
Before
51