Table of Contents
Advertisement
ASSEMBLY
UNPACKING
CARTON
(See Fig. 2)
•
I&
CAUTION:
Be careful
of exposed
I
staples when handling or disposing
of cartoning material.
IMPORTANT:WHEN UNPACKINGANDASSEMBLING TILLER,
BE CAREFUL NOT TO STRETCH OR KINK CABLES.
•
While holding handle assembly, cut cable ties securing
handle assembly to top frame and depth stake. Let
handle assembly rest on tiller.
•
Remove top frame of carton.
•
Slowly ease handle assembly up and place on top of
carton.
•
Cut down right hand front and right hand rear corners
of carton, lay side carton wall down.
•
Remove packing material from handle assembly.
HANDLE
SHIFT ROD
FIG. 2
INSTALL
HANDLE
(See Figs. 3, 4, and 5)
•
Insert one handle lock (with teeth facing outward) in
gearcase notch.
(Apply grease on smooth side of
handle lock to aid in keeping lock in place until handle
assembly is lowered into position.)
VIEWED FROM R.H. SIDE OFTILLER
_
HANDLE ASSEMBLY
\ \\
.%%.CASE
.ANDLE
FIG. 3
Grasp handle assembly. Hold in "up" position. Be sure
handle lock remains in gearcase notch. Slide handle
assembly into position.
HANDLE ASSEMBLY
"UP" POSITION
FIG. 4
•
Rotate handle assembly down. Insert rear carriage bolt
first, with bolt head on L.H. side of tiller and loosely
assemble Iocknut (See Fig. 5).
•
Insert pivot bolt in front part of plate and tighten.
•
Cut down remaining corners of carton and lay panels
flat.
•
Lower the handle assembly. Tighten nut on carriage
bolt so handle moves with some resistance. This will
allow for easier adjustment.
•
Place flat washer on threaded end of handle lock le-
ver.
•
Insert handle lock lever through
handle base and
gearcase. Screw in handle lock lever just enough to
hold lever in place.
•
Insert second handle lock (with teeth inward) in the
slot of the handle base (just inside of washer).
•
With handle assembly
in lowest position,
securely
tighten handle lock lever by rotating clockwise.
Leav-
ing handle assembly in lowest position will make it
easier to remove tiller from carton.
CARRIAGE
BOLT
GEARCASE
SLOT
HANDLE
BASE
HANDLE
LOCK
FLAT
WASHER
HANDLE
LOCK
-_-7
PIVOT BOLT
LOCKNUT
FIG. 5
5
Advertisement
Table of Contents
