Adding Detergent And Care Product; Starting The Programme; Adding Laundry; Cancelling The Programme - Bosch WGG254FKGR User Manual And Installation Instructions

Table of Contents

Advertisement

13.5 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 30.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 30
Press Έναρξη/Προσθήκη
ρούχων .
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "End".
13.7 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press Έναρξη/Προσθήκη
1.
ρούχων .
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 22
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press Έναρξη/Προσθήκη
5.
ρούχων .
13.8 Cancelling the pro-
gramme
Press Έναρξη/Προσθήκη
1.
ρούχων .
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Ξέβγαλμα programme.
– If the water level is high, start
the Στύψιμο programme or se-
lect a suitable programme for
draining.
→ "Programmes", Page 25
Remove the laundry.
3.
→ "Unloading the laundry",
Page 32
13.9 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
Set the Στύψιμο programme or a
1.
programme for draining the water.
→ "Programmes", Page 25
operation en
31

Advertisement

Table of Contents
loading

Table of Contents