Table of Contents
Advertisement
After replacing QA02, the following initialization is required.
CAUTION: Never attempt to initialize the data unless QA02 has been
replaced.
1. Enter the service mode, then select any register item.
2. Press and hold the CALL button on the remote control, then press the CH
the TV.
The initialization of QA02 has been completed.
3. Check the picture carefully. If necessary, adjust any adjustment item above.
Perform "Auto tune" on the owner's manual.
Test Signal Selection
Every pressing of
button on the remote control changes the built-in test patterns on
screen as described below in Service Mode.
Picture
Signal
Red raster
Green raster
Blue raster
button on
Advertisement
Table of Contents
