Manufacturer's Warranty; Further Information - Hilti NURON DSH 600-22 Original Operating Instructions

Trouble or fault
Cut-off saw does not run.
High vibration, wheel wanders
off the cutting line.
Insufficient or no flow of wa-
ter.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12

Further information

For more information on operation,
http://qr.hilti.com/manual/?id=2284138
This link is also to be found at the end of the documentation, in the form of a QR code.
Mode d'emploi original
1 Indications relatives au mode d'emploi
1.1 À propos de ce mode d'emploi
• Avant de mettre l'appareil en marche, lire impérativement ce mode d'emploi.
préalablement requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements du présent mode d'emploi ainsi que celles
figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement transmettre le produit à des
tiers accompagné de ce mode d'emploi.
18 Français
Possible cause
Battery not fully inserted.
The cut-off wheel is not correctly
fitted and tightened.
Cut-off wheel is damaged (or un-
suitable specification, cracked,
segments missing, bent, over-
heated, deformed, etc.).
The centering bushing is fitted in-
correctly.
Water nozzles are blocked.
technology, environment and recycling,
Action to be taken
▶ Check that all batteries are
correctly inserted and engaged.
▶ Check how it is fitted and the
tightening torque.
▶ Change the cut-off wheel.
▶ Check that the diameter of the
arbor hole in the cut-off wheel
matches the centering collar
of the cut-off wheel centering
bushing.
▶ Clean the water nozzles.
follow this link:
C'est la condition
2284138
*2284138*