Operation - Hilti NURON DSH 600-22 Original Operating Instructions

5.6 Adjusting the guard
WARNING
Risk of injury. Contact with the cut-off wheel, flying fragments or sparks can cause injury to persons.
▶ Adjust the guard so that flying particles or fragments of the material removed and flying sparks are
directed away from the operator and the product.
▶ Hold the guard by the grip provided and rotate it to the desired position.
5.7 Installing cut-off saw on saw trolley (accessory)
DSH 700-22
Before starting installation of the power tool on the saw trolley, install the wheel set (accessory).
1. Remove the water tank from the saw trolley.
2. Move the cutting depth adjustment lever into the upper position.
3. Open the hold-down device by releasing the screw knob.
4. Set the cut-off saw with the wheels in front mount (1) and swivel the grip of the cut-off saw underneath
hold-down device (2) .
5. Secure the cut-off saw by tightening screw knob (3) .
6. Secure the throttle cable to control switch (4) .
7. Fit the water tank after filling it.
8. Connect the water hose to the cut-off saw by means of a Gardena coupler.
9. Adjust the grip to a convenient working height.
10. Adjust the guard to the correct position. → page 14
5.8 Preparations for dust extraction module
5.8.1 Installing dust extraction module (accessory)
Used in combination with an industrial vacuum cleaner, the dust extraction module reduces the amount of dust
created by dry-cutting operations. Use the dust extraction module only for dry-cutting in mineral materials.
The severe heat produced by cutting in metals or use for wet cutting will destroy the dust extraction module.
Read and observe the instructions on safety and use in the operating instructions of the accessory.
1. Clean the blade guard and the notches for installation of the dust extraction module.
2. Move the blade guard until the installation position of the dust extraction module is freely accessible.
3. Slacken the nut on the dust extraction module until the housing parts can be opened as far as the end
stops on the connecting axle.
4. Engage the dust extraction module in the notches provided for the purpose in the blade guard.
▶ The notches slide smoothly into engagement without jamming.
5. Tighten the nut hand-tight.
6. Return the blade guard to the closed position.
7. Connect an industrial vacuum cleaner suitable for the application to the dust extraction module.
5.8.2 Removing dust extraction module (accessory)
1. Move the blade guard until the installation position of the dust extraction module is freely accessible.
2. Slacken the nut on the dust extraction module.
3. Disengage the dust extraction module from the blade guard.
4. Return the blade guard to the closed position.
6

Operation

Unless otherwise stated, the descriptions below are applicable for DSH 600-22 and DSH 700-22.
14 English
4
5
2284138
*2284138*