Philips DVP3150V/37 Service Manual page 49

Hide thumbs Also See for DVP3150V/37:
Table of Contents

Advertisement

Main CBA Top View
CAUTION !
Fixed voltage (or Auto voltage selectable) power supply circuit is used in this unit.
If Main Fuse (F1001) is blown , check to see that all components in the power supply
circuit are not defective before you connect the AC plug to the AC power supply.
Otherwise it may cause some components in the power supply circuit to fail.
Sensor CBA Top View
BHF300F01012A
BHF300F01012B
TO SENSOR CBA
(END-SENSOR)
WF2
TP302
RF-SW
WF3
TP301
C-PB
TP513
CTL
VR501
SW-P
CAUTION !
F
For continued protection against fire hazard,
replace only with the same type fuse.
A
V
ATTENTION : Pour une protection continue les risqes
d'Incele n'utiliser que des fusible de même type.
Risk of fire-replace fuse as marked.
"This symbol means fast operating fuse."
"Ce symbole reprèsente un fusible à fusion rapide."
TO SENSOR CBA
(START-SENSOR)
1-13-17
Because a hot chassis ground is present in the power
supply circut, an isolation transformer must be used.
Also, in order to have the ability to increase the input
slowly, when troubleshooting this type power supply
circuit, a variable isolation transformer is required.
NOTE:
The voltage for parts in hot circuit is measured using
hot GND as a common terminal.
WF1
TP751
V-OUT
DVD Open/Close
CBA Top View
BE8A00F01013C
Power SW CBA
Top View
BE8A00F01013B
Note:
L1004 is positioned on the Cathode
side of D1011 as shown below.
D1011
L1004
TP502
S-INH
BarthService
BE8A00F01013A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents