Table of Contents
Advertisement
Diagnostic software descriptions and troubleshooting
5. Diagnostic software descriptions and troubleshooting
5.1
Dealerscript
5.1.1
Purpose of Dealer Script
The dealer script can give a diagnosis on a standalone DVD
player; no other equipment is needed to perform a number of
hardware tests to check if the DVD player is faulty. The
diagnosis is simply a "error" or "pass" message; no indication
is given of faulty hardware modules. Only tests within the
scope of the diagnostic software will be executed hence only
faults within this scope can be detected.
Nucleus
VideoColSetupComm
PapChksFl
PapI2cDisp
PapS2bEcho
PapI2cNvram
PapNvramWrR
CompSdramWrR
Press 2 keys simultaneously
<OPEN/CLOSE> + <PAUSE>
During the test, the following display
is shown: the counter counts down
from the number of nuclei to be run
before the test finishes. Example:
www.rtv-horvat-dj.hr
Description
7
Checks the I2C interface with the RGB video processor on the Audio/Video
board (only for DVD players with RGB video processor).
Calculate and verify checksum of FLASH memory.
6
5
Checks the I2C interface with the slave processor on the display PCB.
4
Checks the I2C interface to the basic engine.
3
Checks the I2C interface with the NVRAM.
2
Pattern test of all locations in the NVRAM
Pattern test of all locations in the SDRAM(s).
1
Connect to mains.
NO
SET O.K.?
YES
5.1.2
Contents of Dealer Script
The dealer script executes all diagnostic nuclei that do not
need any user interaction and are meaningful on a
standalone DVD player.
The nuclei called in the dealer script are the following (the
number after each nucleus name corresponds with the
number being on the local display when the nucleus is
executed during the dealer script):
Figure 5-1
To exit DEALER SCRIPT ,disconnect from mains.
Figure 5-2
DVD612 /XX1
5.
CL06532096_001.eps
CL 96532065_004.eps
120799
GB 21
050700
Advertisement
Table of Contents
