Maintenance; Quarterly Maintenance - Broan SKY Series Installation And User Manual

5 Maintenance

Risk of electric shock. Before performing any maintenance or servicing, always turn power off at service panel or
disconnect the unit from the outlet. When cleaning the unit, it is recommended to wear safety glasses and gloves.

5.1 Quarterly Maintenance

1. Disconnect unit or turn power off at service panel.
2. Open unit door by following the steps and referring to illustrations below:
erVs100s-hw
Push on the door retaining
tabs to
tabs from the unit frame (see
VR0112
insets).
l
atches
VB0347
3. While holding the core () if unit is installed in or under the ceiling,
loosen the wing nut () and rotate the core retaining bracket (shaded
part in illustration at right). Slide out the core with its filters.
If the unit is installed in or under the ceiling, always hold
the core when rotating the core retaining bracket; failure
to do so will cause the core to fall out.
4. Wash both core filters under lukewarm water with mild soap. Rinse
and let dry completely before reinstalling on the core. Refer to the
core label for proper location.
5. Slide the core with its cleaned filters in the unit. Refer to filter location
indicators embossed inside the unit to position adequately the core.
Use the core bracket and wing nut to lock the core in place.
6. Reinstall and close the door, then restore power.
erVs100s-hw-m
And
disengage these
erVs100s-pc
Unlatch both side latches. If the door must be removed to ease maintenance or if the
clearance is not sufficient, remove the nut on the latch then slide the door sideways once
the door slightly opened.
! WARNING
! WARNING
Rotate the door and
remove it.
VO0274
14
CAUTION
Be careful when opening
the door; water may be
present when there is
a significant difference
between the outside and
inside temperature.