Advertisement
□ Main Unit Preparation
• The following must be completed before operating.
(A battery is already loaded in the main unit when purchased.)
o Setting the distance scale
Press all three buttons simultaneously (select button, mode button and start/stop button) to clear all data. All
displays will illuminate for 2 seconds. Then mile/h alone will be displayed as illustrated in Fig. 1. Km/h and mile/h
are alternately displayed each time the start/stop button is pressed Select either as desired. Next, press the
mode button, and the distance scale will be set and displayed as shown in Fig. 2.
* How to replace the battery
Turn the main unit over, remove the battery case cover using coin or similar opener as illustrated in Fig. 3, and
insert a new lithium battery (CR 2032). Positioning the (T-) pole upward as illustrated, place the battery properly
into the case and close the cover securely.
-9-
Advertisement
