Table of Contents
Advertisement
Removing and refitting the door panels
The glass panels can be removed from the oven door
to allow more thorough cleaning.
Removing
Detach the oven door. To do this, read the section
1.
entitled
"Detaching the door"
on a cloth with its handle pointing downwards.
Remove the cover at the top of the oven door. To do
2.
this, press in the tabs on the left and right using your
fingers. Pull out and remove the cover (Fig. A).
Lift the top panel up and out (Fig. B).
3.
Clean the glass panels with glass cleaner and a soft
cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Installation
Hold the top panel firmly on both sides and insert it
1.
at an angle towards the back. When doing so,
ensure that you push the panel into the openings on
the underside. The smooth surface must face
outwards and the rough surface must face inwards.
(Fig. A).
Place the cover at the top of the oven door and
2.
press it on. Make sure that the lugs on both sides
engage.
Attach the oven door. To do this, see the section
3.
entitled
Attaching the oven door
Only use the oven once the glass panels have been
correctly fitted.
. Position the oven door it
.
pRails
W ith good care and cleaning, your appliance will retain
R a i l s
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.
Detaching and refitting the rails
The rails can be removed for cleaning. The oven must
have cooled down.
Detaching the rails
Lift up the front of the rail
1.
and unhook it (figure A).
2.
Then pull the whole rail forward
3.
and remove it (Fig. B).
4.
Clean the rails with cleaning agent and a sponge. For
stubborn deposits of dirt, use a brush.
Refitting the rails
First insert the rail into the rear socket, press it to the
1.
back slightly (figure A),
and then hook it into the front socket (figure B).
2.
The rails only fit on the right or the left side. Ensure that,
as shown in figure B, levels 1 and 2 are below and
levels 3, 4 and 5 are above. The pull-out rail must be
pulled out forwards.
Rails
en
27
Advertisement
Table of Contents
