Water Dispenser - Thermador T48BT110NS Use And Care Manual

en-us Water system
Changing the water filter or replacing it with a
bypass cap
Hinge the filter cover upwards.
1.
Turn the water filter counterclockwise by 90°
2.
remove it ⁠ .
Remove the water filter with care as it is under
‒
pressure.
Note: When removing it, a small amount of water may
drip out of the water filter. Remove the drips of water
with a dry cloth.
Tip: You can dispose of the old water filter with your
household garbage.
Insert the new water filter or the bypass cap all the way
3.
into the filter opening and turn it 90° clockwise until it
stops.
Close the filter cover.
4.
Discard the ice cubes produced during the first
5.
24 hours, and dispense water for 5 minutes and
discard.
22
18.2 Water dispenser
Dispense cold water via the water dispenser.
Putting the water dispenser into operation
Note: Once the appliance has been connected or a new
water filter has been installed, there will be air in the water
system.
Requirement: The appliance is connected to the drinking
water connection.
Keep dispensing water until it contains no more air
1.
bubbles.
Remove any splashes of water with a dry cloth.
For hygiene reasons, dispense water for 5 minutes and
2.
discard.
Dispensing water
Press and hold the glass against the dispensing button
▶
and
or hold the glass under the water dispenser and
press ⁠
Notes
After a while of continuous dispensing, the water
¡
stops being dispensed. Wait a few seconds before
dispensing water again.
After water has been dispensed several times
¡
consecutively, water stops being dispensed. Wait a
few minutes before dispensing water again.
Water dispenser keylock
The button lock prevents the water dispenser from being
operated accidentally or incorrectly while running.
Switching on the water dispenser button lock
Swipe to Water.
1.
Press and hold Hold to unlock until the light bar lights
2.
up fully.
Lock icon lights up.
a
Switching off the water dispenser button lock
Swipe to Water.
1.
⁠ .