Table of Contents
Advertisement
Changing a User Password
All other users can have Read Only access, but not Read/Write access.
Step 2
Click ✚ to add a new row.
Step 3
Check the checkbox for a new user and enter a name for the new user.
Step 4
Enter a new password between 0 and 127 characters and confirm the same password in the appropriate fields.
The Password Strength Meter field indicates the password strength as follows:
• Red — The password fails to meet the minimum complexity requirements.
• Orange — The password meets the minimum complexity requirements but the password strength is weak.
• Green — The password is strong.
Step 5
Click Apply.
Note
To delete a user, select the user name and click Delete. To edit an existing user, select the user name and click
Edit, then click Apply to save all changes made to the configurations.
Changing a User Password
To change a user password:
Step 1
Select System Configuration > User Accounts.
The User Account Table shows the currently configured users. The user cisco is preconfigured in the system to have
Read/Write privileges. The password for the user cisco can be changed.
Step 2
Select the user to configure and click Edit.
Step 3
Enter a new password between 0 and 127 characters and confirm the same password in the appropriate fields.
The Password Strength Meter indicates the password strength as follows:
• Red — The password fails to meet the minimum complexity requirements.
• Orange — The password meets the minimum complexity requirements but the password strength is weak.
• Green — The password is strong.
Step 4
Click Apply. The changes are saved to the Startup Configuration.
If you change your password, you must log in again to the system.
Note
Management
This section describes how to configure the management settings on the WAP device.
Cisco WAP150 Wireless-AC/N Dual Radio Access Point with PoE / Cisco WAP361 Wireless-AC/N Dual Radio Wall Plate Access Point with PoE
30
System Configuration
Advertisement
Table of Contents
