J
.
.
.
.....
...
-
W
TO REMOVE BOBBIN CASE
TO REPLACE BOBBIN CASE
veReturnleVer bbn(2)
to lockingcae
position
Open slide plate and remove bobbin.
Lift needle plate (1) by right corner.
Push lever (2) toward you until it
Push lever (2) toward you.
NOTE: After locking bobbin case
stops, and hold in this position,
in place, be sure it is not tight, but
can move slightly.
Lift bobbin case up and guide it
Guide bobbin case into place,
To replace needle plate, slide it
out toward you, as shown,
making sure block (3) is under
under pin (5) and push it to the
metal bracket (4)
left,
-25-