Leveling; Turning On The Power - LG LDNS22220 Series Owner's Manual

Leveling

Leveling the Refrigerator
The refrigerator has two front leveling legs. Adjust
the legs to alter the tilt from front-to-back or side-
to side. If the refrigerator seems unsteady or the
doors do not close easily, adjust the refrigerator's
tilt, using the instructions below:
1
Turn the leveling leg to the left to raise that
side of the refrigerator or to the right to lower
it. It may take several turns of the leveling leg
to adjust the tilt of the refrigerator.
NOTE
• A flare nut wrench works best, but an open-end
wrench will suffice. Do not over-tighten.
2
Open both doors, and check to make sure
that they close easily. If the doors do not close
easily, tilt the refrigerator slightly more to the
rear by turning both leveling legs to the left. It
may take several more turns, and be sure to
turn both leveling legs the same amount.
Door Alignment
If the space between your doors is uneven, follow
the instructions below to align the doors.
1
Remove the top hinge cover screws. Lift the
hook located at the bottom of the front side of
the cover with a flat-head screwdriver.
2
Loosen the top hinge bolts using a 13/32 in.
(10 mm) socket wrench or open-end wrench.
3
Have someone hold the refrigerator door so
the space between the two door is even, and
retighten the top hinge bolts.
4
Replace the top hinge cover.

Turning on the Power

• After installing, plug the refrigerator's power
cord into a 3-prong grounded outlet and push
the refrigerator into the final position.
CAUTION
• Connect to a rated power outlet.
• Have a certified electrician check the wall outlet
and wiring for proper grounding.
• Do not damage or cut off the ground terminal of
the power plug.
Position the Refrigerator
• If the refrigerator is connected to water, arrange
the coil of tubing so that it does not vibrate
against the back of the refrigerator or against
the wall. Push the refrigerator back toward the
wall, leaving adequate clearance.
Start the Icemaker
• If the water line is connected, set the icemaker
power switch to the ON position.
• The icemaker will not begin to operate until it
reaches its operating temperature of 15 °F (–9
°C) or below. It will then begin operation
automatically if the icemaker power switch is in
the ON (I) position.
INSTALLATION 23