Sony DVP-NS41P Operating Instructions Manual page 4

• Nevm place the set in a _ ....
coniined space, such as a
bookcase, oi built-in E'_
cabinet, mfless propel
ventilation is provided.
• Do not place the set near oi .__ _.
over a radiatoi or heat _- ; '_ _ >
register, or where it is
exposed to direct stmlight
Antennas
Outdoor antenna grounding
If an outdom amelma or cable sy'stem is installed,
follow the precautions below.
An outdoor antelma systeln should not be located m the
vicinity, of overhead power lines or other elecnic light
or power circuits, or where it can COllie in contact with
such power lines or circuits
WHEN INSTALLING AN OUTDOOR ANTENNA
SYSTEM, EXTREME (?ARE SHOULD BE TAKEN
TO KEEP FROM CONTACTING SUCH POWER
LINES OR (IRCUITS AS (ONTACT WITH THEM
IS ALMOST INYARIABLY FATAL
Be sure the antemm systeln is
gt ounded so
as to provirte
some protection against voltage smge s and built-up static
charges Seetmn 810 of tlle Natio_ml Electrical Code
provides nYD1Rllalionmtll respect to ploper _m-omldmgof
the nmst and suppollmg stmcnn-e, gl-olmdmg of tbe lea&in
wire m an anemia discharge umL size of g_omlding
coIldltctol'S,
locatton ofantemm-discbarge mitt. colmection
to _mmding electrodes, and requirements for tbe
_'omMing electrode
Antenna Grounding According to the
National Electrical Code
Antenna Discharge unit
(NEC Section 810-20)
Grounding Conductors
(NEC Section 810-21)
Ground Clamps
Power Service Grounding
Electrode System
(NEC Art 250 Part H
NEC-NATIONAL ELECTRICAL CODE
Lightning
Fm added protection fol this set din-ms a lightning
storm, or when it is left unattended and unused for long
periods of time, unplug it fiOln the wall outlet and
discolmect the antelma or cable system This will
prevent damage to tbe set due to lightning and power-
line surges
Service
Damage Requiring Service
Unplug tile set from the wall outlet and refer smvicing
to qualified service personnel under the following
conditions:
• When the power cord or phlg is '=21T'1_¢,,_==
damaged m frayed _art_ oR"taut
c J,Y_
6RAt.K_D 1_tt_
• If liquid has been spilled or
o[!iects have fhllen into the
set
• If the set has been exposed
to rain or water.
• If the set has been _ _
subject to excessive
shock by being
dropped, or the cabinet
has been damaged
• If the set does not opmate
normally when following _
the operating instructions. ' _ -_
Adjust onl) those contiols
that are specified in the
operating instructions, hnproper a_liustment
of other controls may result in damage and
will often require extensive x_ork by a
qualified technician to restore the set to normal
operation.
• When the set exhibits a distinct change in
performance - this indicates a need for selaice
Servicing
Do not attempt to smvice the set
yourself as opening or removing
covers nlay expose you to
dangerous voltage or other
hazards
Refer all servicing to qualified selwice personnel
Replacement parts
Wben replacement parts ate required, be sure the
selwice teclmician has used replacement pal_s specified
by the manufacturer that have the same characteristics
as tile original parts
Unmtthorized substitutions may result in fire, electric
shock, or oilier hazards
Safety Check
UpoIl
completion of any service oI
repairs to the set, ask tbe sela'ice
teclmician to perform routine
safety checks (as specified by file
manufacturer) to determine that
the set is in safe operating
con&don