global_main.book.book Page 22 Friday, May 12, 2023 4:36 PM
INSTALLATION
22
6
Use the provided tie strap
drain hoses in place.
NOTE
• The drain hose should not be placed higher than
100 cm above the floor. Water in the appliance
may not drain or may drain slowly.
• Securing the drain hose correctly will protect the
floor from damage due to water leakage.
• If the drain hose is too long, do not force it back
into the appliance. This will cause abnormal
noise.
Connecting Hoses to the Drain
Hose Connector
1
Slide the included band clamp onto the end of
the drain hose of the washer.
2
Connect the drain hoses from the washer and
dryer to the drain hose connector. Tighten the
to secure the 2
c
3
4
• Adjust the wire hose clamp to prevent the hose
band clamp
to keep the washer hose in
a
place.
Use the band clamp
on the short drain hose
b
(included) to attach it to the bottom opening of
the drain hose connector.
Connect securely the short drain hose to a floor
gully or a standpipe.
When connecting to a waste spigot, use the
band clamp
to the end of the short drain
c
hose.
105 cm
105 cm
CAUTION
from coming loose or leaking. Failure to do so
could result in flooding. Use of the drain hose