Table of Contents
Advertisement
(3)Advanced
Control via MIDI
G Using another MIDI sound module
If you wish to extend the number of sounds using another MIDI sound module, make connections as
follows.
Set the MIDI receive channel of the connected sound module to a number other than the
MIDI receive channel used for the CM-32L (channels 1, 11 - 16).
MIDI
OUT
Computer,
н
MIDI Sequencer,
etc.
MID! Sound Module
|
G Bender Range Control with RPN
The CM-32L
allows you to control
the bender range of each Part using the RPN
(Registered
Parameter Number).
То do that, send Control Change messages from an external MIDI device in the sequence shown
below :
(p RPN MSB (Control Number : 100/64H)
0/00Н
@ RPN LSB (Control Number : 101,/65H)
0700Н
(3 Data Entry(Control Number:
6/06H)
vv
жуу is the value of the bender range to be set.
It can be set in semi-tone steps within 2 octaves (0 - 24," 00H -
18H).
< Example»
To set the bender range of Part 4 (MIDI channel 5) to 12 (1 octave):
Control
Number
DRPN
MSB
f
100/64H
0/00H
RPN LSB
:
101/65H
0/00H
Data Entry
5.
С
6/06H
12/0CH
MIDI ch
Data
MIDI Message
ВАН, 64H, 00H
B4H, 65H, 00H
B4H, 06H, 0CH
ж Some types of MIDI sequencer transmits Control Change numbers of the same step (timing) in the sequence of
smaller number to larger number.
If you use this type of sequencer, be sure to set it so that the Control Change
will be sent in the sequence of RPN MSB - RPN LSB - Data Entry by sifting the position of the RPN forward, etc.
G Control using the Exclusive Messages
Exclusive messages are messages exclusive to a particular manufacturer, such as sound data and
setup data.
Various parameters can be controlled using the Exclusive messages.
For details, see the MIDI Implementation at the back of this owner's manual.
16
Advertisement
Table of Contents
