Table of Contents
Advertisement
Screws
^ SEAT ASSEMBLY
Turn seat around if it is facing backwards, or remove
from box. Remove the four screws from the bottom of
the seat. Place the seat in position against the seat
pivot bracket, lining up the slotted holes in the pivot
bracket with the holes in the seat. Select desired posi¬
tion for the seat, and secure with the four screws. See
figure 2.
ATTACHING THE DECK LINKS (Hardware A)
The three adjustable deck links have been shipped
unassembled. Attach as follows.
1. Start 1/2" hex nuts on eyebolts provided. Insert
the hex nuts and eyebolts into the adjustable lift
-links as shown in figure 3.
2. Thread eyebolts into the lift links and hex nuts.
The left rear link should be adjusted so the eyebolt
is to the lower mark as shown. The two front links
should be adjusted to the higher mark.
FIGURE 3.
ATTACHING THE CUTTING DECK (Hardware C)
1. Move the tractor lift handle all the way back to
the full raised position. Turn the tractor steering
wheel all the way to the left.
2. The two deck stabilizers and the diagonal brace
which are attached to the front of the deck are
folded back over the deck for shipping purposes.
— Unfold them at this time. See figure 4.
FIGURE 4.
8
Advertisement
Table of Contents
