General Care And Maintenance - True SPL0400 Owner's Manual

GENERAL CARE AND MAINTENANCE

IMPORTANT
!
Preventative maintenance is crucial to maintaining the function and safety of this equipment. Your facility must establish
written guidelines for preventative maintenance and keep written or online records of the maintenance performed on these
products. As a minimum, the items presented in the SAFETY section of this document and the items that follow here,
should be included in your maintenance program.
● Cables (if equipped)—inspect end fi ttings daily for wear. Inspect the entire length of the cable weekly. Replace cables
at the fi rst sign of wear and on an annual basis. If the cable tension has been adjusted, be certain that the cable nut is
tight.
● Nuts, bolts, and fasteners—check tightness weekly. If any hardware has become loose, retighten and/or use Loctite
brand Threadlocker 242. Be sure all hardware is tight before using the machine.
● Safety catches—inspect catches, stop rods and their associated fasteners. Tighten any loose hardware and replace
any components at fi rst signs of wear.
● Frames—sweat, disinfecting sprays and spills can lead to corrosion which may lead to premature failure of
components. Wipe all machines down with a damp cloth and dry completely each day. This includes painted parts,
chrome parts and upholstered pads.
● Painted and chrome plated parts—use Simple Green with a dilution of 32:1 or similar cleaner for light dirt and grime.
Use Turtle Wax Polishing Compound or a good car polish to remove heavier dirt and grease as well as for polishing.
DO NOT use solvents, lacquer thinner, acetone or fi nger nail polish remover. For scuff s and marks that are not
removed by the above methods use a soft scrub cleanser. Make sure all parts are dry upon completion.
● Weight stack enclosures (shrouds) (if equipped)—wipe down with a damp cloth as needed.
● Exercise instruction labels—clean with soap and water as needed.
● Guide rods (if equipped)—wipe all dirt and dust from the guide rods before applying a light application of Tri-Flow
other tefl on spray lubricant. Spray the Tri-Flow
lubricants such as WD-40.
CAUTION: Tri-Flow
!
● Bronze bushings—check monthly for signs of wear and replace as needed.
● Linear bearing shafts—wipe any accumulation of dust or other contaminants from the shafts on a weekly basis. Apply
a thin layer of a Tefl on
● When replacing any component, use only TRUE supplied parts.
● Be sure all hardware is tight before using the machine.
Retain these instructions for future reference. If you have any questions, do not hesitate to contact your TRUE dealer or
TRUE product support (service@truefi tness.com // 800.883.8783).
8
TM
will stain carpet and clothing.
TM
(PTFE) grease on a weekly basis. TRUE recommends Magnalube
®
on a rag and then wipe the guide rods with the rag. DO NOT use oil
TM
TM or
brand.
®