Belt Maintenance; Inspecting The Belts; Replacing The Mower Belt - Toro Titan ZX4875 Operator's Manual

Belt Maintenance

Inspecting the Belts

1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine and wait for all moving parts to stop before leaving the operating
position.
3. Set the height of cut at the lowest cutting position.
4. Inspect the belt for wear. Replace the belt if it is worn.
The signs of a worn belt include squealing while the belt is rotating; the blades slipping
while cutting grass; and frayed edges, burn marks, and cracks on the belt.

Replacing the Mower Belt

The signs of a worn belt include squealing while the belt is rotating, blades slipping while
cutting grass, and frayed edges, burn marks, and cracks on the belt. Replace the mower belt
if any of these conditions are evident.
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
3. Set the height of cut at the lowest cutting position.
4. Release the mower-deck curtain.
5. Remove the pulley covers.
6. Loosen the nut securing the wire form to the idler pulley.
3464-637A
position.
ARK
position.
ARK
G453681
Page 5–21 Maintenance: Belt Maintenance