1030 M.2 Solid-State Drive And Bracket - Lenovo ThinkPad X1 Carbon Gen 12 Hardware Maintenance Manual

If the Vantage app is not installed on the computer, the customer should download and install the program to
diagnose the built-in battery, before getting a non-physically damaged built-in battery replaced. Note that the
replacement of a physically damaged built-in battery is not covered by the warranty.
For access, remove this FRU:
• "1010 Base cover assembly" on page 56
Removal steps of the built-in battery
When installing:
• Ensure that no any foreign material or screws are left on the battery area before installing.
• Align the connector of the built-battery with the key in the slot. Then, insert the battery into the slot at an
angle of about 35 degrees and pivot the battery downwards. Press the battery connector and tighten
screws to secure built-in battery assembly.

1030 M.2 solid-state drive and bracket

For access, remove this FRU:
• "1010 Base cover assembly" on page 56
Attention: The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data.
When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for repair. The M.2 solid-state drive is not designed for frequent
changes or replacement.
• Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
• Do not apply pressure to the M.2 solid-state drive.
• Do not touch the contact edge or circuit board of the M.2 solid-state drive. Otherwise the M.2 solid-state
drive might get damaged.
• Do not make the M.2 solid-state drive subject to physical shocks or vibration. Put the M.2 solid-state drive
on a soft material, such as cloth, to absorb physical shocks.
• Remove or insert the M.2 solid-state drive horizontally. Otherwise the slot might get damaged.
58
ThinkPad X1 Carbon Gen 12 Hardware Maintenance Manual