Table of Contents
Advertisement
captors
|| [I] TTHHII
6-12 (E)
Setting Transition Points During Preview or
Edits — SYNC Roll Editing
Chapter 6 Advanced Editing
Using two synchronized players, you can begin a special effect transition at any
point in the edit.
To perform a SYNC
roll edit, proceed as follows.
ae
con
Use other buttons and controls as
necessary to control the players and recorder.
SYNC roll editing procedure
1
Select the edit mode.
2 Press the SYNC (ENTRY + A/B) button.
The button lights. The green FROM indicator in the source selection section
lights.
3 Select the FROM and TO sources.
4 Set the edit points for the recorder and the FROM and TO sources.
e If the FROM and TO sources are VTRs (corresponding to the P1 and P2
buttons), you do not need to set their OUT points. The OUT points will be
calculated automatically at the time when you execute the edit or preview.
e If the FROM or TO source is an auxiliary source, corresponding to the
AUX1 (ENTRY + P1), AUX2 (ENTRY + P2) or AUX3 (ENTRY + FROM
TO) button, or if the FROM or TO source is being used in DT editing, youdo
not need to set the duration.
5 Set the transition time.
If a preview is unnecessary, proceed to step 8.
6 Execute a preview.
The FROM and TO sources begin to run simultaneously. When the recorder
passes its IN point, the TRANS button begins to flash rapidly and the duraticn
is shown in the EDIT NO/TRANS/DUR display.
Advertisement
Table of Contents
