Roland alpha JUNO-2 Owner's Manual page 15

1. Tuning
Example V
This function is used to tune with other instru-
ment. The pitch of Ad key can be set to 430 to
454 Hz.
The Display @ shows the pitch currently set, and if
"p>" mark is shown on the left of the Display, the
actual pitch of the a JUNO is slightly lower than
the set pitch shown in the Display. If "<4" mark is
shown on the right side of the Display, the pitch is
higher. When both "P" and "<4" marks are
shown at the both ends of the Display, tuning is
done.
2. Modulation Sensitivity
Example V
When the Pitch Bender/Modulation Lever @ con-
trols the Modulation effect, this function deter-
mines the depth of the Modulation effect from 0 to
127.
3. Portamento Time
Example V
When the Portamento effect is on, this function
sets the time needed for the slide of the pitch from
one note to another.
* At0, no portamento effect is obtained, and 127 is
the longest time.
4. Preset Tone Colors' DCO Pitch Bender Range
Example ¥
When the Pitch Bender/Modulation lever controls
the Pitch Bender effect of the whole preset tone
colors (P-11 to 88), this sets the depth of the effect
from 0 to.12.{1. represents semi-tone).
5. Pedal Switch
Example ¥
This function selects which of the Program Shift,
Portamento, or Chord Memory function works by
the pedal switch connected to the Pedal Switch
Jack @.
Pressing the pedal switch sequencially calls the tone colors 1 to 8.
After 8, 1 willreturn.
This turns on or off the Portamento effect.
Chord Memory This turns on or off the Chord Memory effect.
* When the Portamento or Chord Memory function is selected, the effect is on while the DP-2 is being depressed.
If you wish to turn the effect on and off alternately by depressing the pedal, use the optional Foot Switch
FS-1.
|
15