Table of Contents
Advertisement
E. Economy
iii. Design:
F. Off
Note:
1. User setting( Brightness/Contrast/Gamma/DCR/color temp) will been store into
EEPROM when switch to SmartImage mode, and keep setting till the user choose recall
all
2. VGA and DVI will keep different SmartImage mode
3. SmartImage will back to off mode if user change color to sRGB
4. Each mode of RGB Gain value for User Define will use the same one
Demo mode
A. Purpose: Built-in demo mode for sales in-store demo.
B. Design:
i. Dynamically split screen to 2 vertical frames with one vertical white line.
ii. The OSD word color is white with transparent background.
iii. The demo profile will be "Video Playback" profile with "High" ODC setting.
2010/11/30
General Product Specification
i. Purpose: Adjust brightness level for reducing power consumptions
ii. No optimization by Smart Image.
1. Brightness level set to 40%, a little higher brightness level than laptop PC, fine
tune brightness level before DVT exit.
2. Color temperature set to 6500K.
3. Gamma set to 2.2.
i. Purpose: No optimization by SmartImage.
ii. Design:
1. This will follow user OSD setting. If any change by user, it will be saved. When
switch back from other SmartImage profiles, it will go back to last saved
setting.
2. Gamma Table is turn on to reduce bad color tracking.
The line width is 2 pixels. The left frame will be enhanced by SmartImage
Premium and right frame remains original performance.
241P3LY
PHILIPS
241P3L LCD
24" Wide FHD LCD Monitor
19 of 33
69
Advertisement
Chapters
Table of Contents
