Onkyo DX-C206 Instruction Manual page 4

Precautions
a
1. Warranty Card
The seriai number is written on the rear panel of this unit. Copy the
serial number and mode! number onto your warranty card and keep
it in a safe place.
Do Not Touch the Player with Wet Hands
Do not handle the player or power cord when your hands are wet
or damp. If water or any ather liquid enters the player cabinet, take
the player to an authorized service station for inspection.
Location of the Player
® Place the Player in a Well-Ventilated Location.
Take special care to provide plenty of ventilation on all sides of
the player especially when it is placed in an audio rack. If
ventilation is blocked, the player may overheat and malfunction.
Do not expose the player to direct sunlight or heating units as
the player's internal temperature may rise and shorten the life
of the pickup.
Avoid damp and dusty places and places directly affected by
vibrations from the speakers. In particular, avoid placing the unit
on or above one of the speakers.
Be sure the player is placed in a horizontal position. Never place
it on its side or on a slanted surface as it may malfunction.
Do Not Place Near Tuners and TV Sets.
If placed next to a TV or other tuner. it may cause reception
interference resulting in some noise in the TV or tuner output.
4. Care
From time to time you should wipe off the front and rear panels and
the cabinet with a soft cloth. For heavier dirt. dampen a soft cloth
in a weak solution of mild detergent and water. wring it out dry, and
wipe away the dirt. Following this, dry immediately with a clean
cloth. Do not use rough material, thinners, alcohol or other chemical
solvents or cioths since these may damage the finish or remove the
panel iettering.
5. Points to Remember
® Ifthe player is brought from a cold environment to a warm one
orisinacold room that ts quickly heated, dew may form on the
pickup, preventing proper operation. In this case, remove the
disc and leave the power ON for about one hour to remove the
dew.
Always close the disc tray when not loading or unloading discs
to protect delicate internal parts from dust.
@ When transporting the player. be careful not to bump it.
Transmitter Battery insertion
4)
a {
x | ow
1. Push the battery cover on the rear of the transmitter in the direction
of the arrow and lift it up.
2 Load the two batteries that came with the transmitter or two
batteries listed in the table. Load them with the + and— ends facing
_ as shown in the diagram.
3 Put the battery cover back in place.
Use of Batteries
@ The remote control transmitter is powered by two batteries.
Before using this unit for the first time. insert the two batteries
(included) as shown tn the diagram.
Average battery life is about one year. This period may be shorter
depending on the frequency of use and environment (temperature
and humidity) in which the remote contro! transmitter is used.
lf the remote control transmitter does not operate even though front
panel controls function normally. the batteries should be replaced.
Use only batteries listed in tne following chart.
3 Type ! Voltage Size
t
! | AA
| Manga | is5y RE
j; nese UM-3 |
NOTES:
1. Do not leave an expired battery in the case as it may leak or
damage the battery case.
When inserting the batteries. be sure the (—) and {-) ends are
, properly aligned.
- 3. Do not use nickel-cadmium (rechargeable) batteries.
_ 4. Do not use one specifiec (manganese) battery and one alkaline
| battery at the same time.
| 5. Replace ooth batteries at once: do not use one old and one new
battery togetner.