Table of Contents
Advertisement
Check ihe following before requesting service;
SYMPTOM
GENERAL
No power.
Power on, but unit not functioning
properiy.
No picture.
No sound.
Playback picture rolls.
The playback picture is poor.
The.Search feature Is not working.
The picture is not fitting properly.
POSSIBLE CAUSE
POSSIBLE SOLUTION
The remote control is not working,
AC cord unplugged.
Condensation has formed.
Wrong type of CD inserted.
Unit needs to be reset.
Plug in the AC cord to an AC outlet
Unplug the unit and wait about one to
two hours to allow the player to dry.
This unit cannot play discs, other than
DVD. VCD or standard CDs.
The disc is dirty or inserted incorrectly,
Some features and functions are not
available on all discs.
The equipment is not connected properly.
The INPUT of the TV is not set to receive
the DVD signal output
Press the STANDBY button, then
unplug the power cord. Wart one minute
and then plug the unit back in.
Clean disc and insert label side-up.
This is normal, try another function.
Connect the equipment according to
the instructions in this manual.
The video cables ana not securely connected.
Progressive Scan switch is set to ON.
The connected TV power is off.
Select the appropriate video input
mode, usually VIDEO orAV.
The equipment is not connected properly.
The equipment connected with the audio
cable is not set to receive the DVD signal
input.
The audio cables are not securely
connected.
The connected receiver's power is off.
Connect the video cables securely.
Set switch to OFF, see bottom of newt pege.
Turn the TV on.
Connect the equipment according to
the Instructions in this manual.
Select the appropriate audio input
mode.
Connect the audio cables securely.
Unit needs to be reset to NTSC.
The disc is dirty.
Some discs have sections that do not
allow searching.
Wrong menu option is selected in the
SETUP MENU.
The PREFERENCES menu cannot
be accessed (it is dimmed) in the
SETUP MENU.
The batteries are weak or dead.
The batteries are not installed properly,
The remote is not aimed at the sensor.
Turn the audio receiver on.
Turn unit off and then back on to auto set it.
Clean the disc.
This is normal on some discs.
Select the correct TV type (PS, LB, WIDE)
which matches the TV you are using.
Install fresh batteries.
Install batteries according to the diagram.
Distance is too far or there is too much
light in the room.
There is an obstacle in the path of the
beam.
There is a CD in the disc tray.
Aim the remote at the sensor.
Operate within 20ft, or reduce the light
in the room.
Move obstacle.
Remove the disc from the disc tray, as
there cannot be any disc inserted when
setting the preferences.
Advertisement
Table of Contents
