Advertisement
Operating the control panel
• Depending on which fabric you have selected, the corresponding light for SYNTH. / SILK / WOOL / COTTON /
LINEN will flash whilst the appliance is adjusting to the correct temperature and steam flow.
• When the red «Water tank empty» light is flashing
button for the light to switch off. See paragraph «Filling the water tank during use»
• When the orange «Anti-Calc» light is flashing : maintenance is required, see paragraph «Maintenance and cleaning».
• Your steam generator comes with an automatic shut-off system which activates if you have not used the generator
for approximately 8 minutes. The blue light for the ON-OFF button flashes to indicate that the generator has switched
to standby. Press the «ON-OFF» button or the steam control button to start ironing again. See paragraph «AUTO-
OFF» System.
Use
Steam ironing
• We recommend that you use a mesh type ironing board to allow steam to pass through
the garments for better ironing results and also to prevent steam venting sideways.
• To obtain steam, press the steam control button under the iron handle. The steam
will stop when you release the button.
• After approximately one minute, and regularly while it is being used, your steam
generator's electric pump injects water into the boiler. It makes a noise but this is
quite normal.
• If you are using starch, always spray it onto the reverse side of the fabric to be ironed.
Smart Technology X-Pert control
Your iron is equipped with the electronic regulation SMART TECHNOLOGY X-PERT
CONTROL which offers five optimal temperature and steam flow combinations.
SYNTH.
(Polyester, Acetate, Acrylic,
Nylon)
SILK
WOOL
COTTON
LINEN
Warning, fabrics with the symbol
Start with the fabrics to be ironed at a low temperature and finish with those that need higher
temperature. When you select a higher temperature, you can continue to iron. If you select a
lower temperature you should wait until the lights stop flashing before you continue to iron (to
allow enough time for the soleplate to cool down). If you are in doubt about the type of fabric an
item of clothing is made from, check the label.
If you are ironing woollen garments, press repeatedly on the steam control button -
without placing the iron on the garment. This will avoid it becoming shiny. The «ECO»
function allows you to reduce energy consumption for the selected mode. To change
to «ECO» mode, select either the SYNTH. / SILK / WOOL / COTTON / LINEN mode
and press on the «ECO»button. The «ECO» button will light up. To exit «ECO» mode,
press the «ECO» button again and the light will go off.
:
the water tank is empty. Fill the water tank and press the «OK»
are not suitable for ironing.
Do not iron over zips, studs or
other hard or sharp objects which
may damage the soleplate. Do
not place the iron on a metal
support. When taking a break
from ironing, always place the
iron on the iron rest plate of the
unit. It is equipped with non-slip
pads and has been designed to
withstand high temperatures.
During use if you
have not used the
steam function for
a few minutes, press
the steam control
button several times
in a row.
Holding the iron
away from your
laundry.
This will remove the
cold water from the
steam circuit.
Advertisement
