Table of Contents
Advertisement
200M ENTERTAINER STEREO MIXER
OWNER'S MANUAL
If an input channel is used, the following can be done
to the tape machine signal:
1. Send the signal to the MAIN outputs and pan
it between the speakers.
2. Send the signal into the monitors.
3. Equalize the signal with the tone controls.
4. Add reverb to the signal.
If TAPE input 9 is used, the following can be done:
1. Send the signal to the MAIN outputs and pan
it between the speakers.
2. Send the signal to the monitors.
If the EFX RETURN is used, the following can be
done:
1. Send the signal to the main outputs.
If the source is stereo, separate inputs must be used
(one panned left, the other right) to maintain stereo
separation. Otherwise, the sound is monol
HOOKING UP INSTRUMENTS DIRECTLY
Instruments are best connected to the 200M through
one of the eight High-Impedance/Line inputs or to
one of the eight Balanced Low-Impedance
Microphone inputs through a direct box or matching
transformer (EV #502CP).
Instruments having high output levels may be con¬
nected to input 9. If sound levels aren't high enough,
use inputs 1 through 8.
EXTERNAL EFFECTS (See Figure 5)
External effects are easily connected to the 200M.
Several points in the 200M's mixer section may be
used for effects returns beside the EFX RETURN
input. These are:
1. Line inputs 1 through 8
2. Line input 9
Using any of these inputs allows the effects signal
into the monitors as well as the mains. Simply turn
up the MONITOR Send control on the effect return
channel.
Be certain that the blend or mix control in the external
effects device is set to the maximum or 100% posi-
seventeen
Advertisement
Table of Contents
