Philips 32PW9788 Instruction Manual page 31

Connect audio receiver
Although your TV is already equipped with a Digital MultiChannel decoder you might want to connect
your own MultiChannel surround receiver.
MultiChannel surround receiver with or without digital input connectors
AUDIO AUDIO
OUT
OUT
DIGITAL
AUDIO
OUT
To select connected equipment
Press the v key on the remote control repeatedly to select
according to where you connected your equipment at the back or the right side of your TV.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
Cinema Link Surround receiver
See the separate supplied Cinema Link instruction manual
Attention: the sound info on screen will not correspond with the actual sound reproduction.
Recorder or DVD with EasyLink
The recorder (VCR or DVD+ RW) or DVD can be
operated with the remote control via the Recorder
or DVD menu on screen.
Recorder
Ò
Rwd Play
DVD
Ò p
Prev. Play
&
é
CENTRE IN CENTRE IN CENTRE IN
"
'
(
p ‡ π †
Stop Play Ffw
‡ π †
Stop Play Next Eject
Connect a MultiChannel surround receiver to the
and connectors at the back of your TV.
R L
If you want the loudspeakers of your TV to act as centre
speaker, also connect an audiocable to the MultiChannel
surround receiver
CENTRE OUT
connector at the back of your TV.
CENTRE IN
Select
Centre input On
loudspeakers of the TV will now only produce centre sound.
If necessary, adjust the volume level of the centre sound in the
menu item of the Source menu.The overall
Centre in volume
volume has to be controlled via the MultiChannel surround
receiver.
In case of a Digital MultiChannel surround receiver, also connect
the receiver to the
DIGITAL AUDIO OUT
In this case the loudspeakers of your TV can not act as centre
speaker. Select Centre input Off
see the instructions manual of your Digital MultiChannel surround
receiver.
EXT1
&
Press the
é
Select the
cursor up/down.
"
Press the cursor left/right, up/down to select
®
one of the recorder or DVD functions.
Ï
Rec Eject
The key ® for recording can be operated in the TV
mode.
If your EasyLink recorder has the system standby
Ï
function, when you press the B key for 3 seconds,
both TV and the recorder are switched to standby.
connector and to the
in the Source menu; See p. 11.The
connector.
in the Source menu, see p. 11. Also
, , ,
EXT2 EXT3 EXT4
key on the remote control.
MENU
or
Recorder
DVD
AUDIO OUT
CENTRE IN
or
SIDE
menu with the
29