Philips 32PW9788 Instruction Manual page 2

Laser Safety
This unit employs a laser. Due to possible eye injury, only a qualified service person
should remove the cover or attempt to service this device.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE.
CLASS 1
LASER PRODUCT
Information for users in the UK
(Not applicable outside the UK)
Positioning the TV
For the best results, choose a position where
light does not fall directly on the screen, and at
some distance away from radiators or other
sources of heat. Leave a space of at least 5 cm
all around the TV for ventilation, making sure
that curtains, cupboards etc. cannot obstruct the
air flow through the ventilation apertures.
The TV is intended for use in a domestic envi-
ronment only and should never be operated or
stored in excessively hot or humid atmospheres.
General Points
Please take note of the section 'Tips' at the end
of this booklet.
Interference
The Department of Trade and Industry operates
a Radio Interference Investigation Service to
help TV license holders improve reception of
BBC and IBA programmes where they are being
spoilt by interference.
If your dealer cannot help, ask at a main Post
Office for the booklet "How to improve
Television and Radio Reception".
Mains connection
Before connecting the TV to the mains, check
that the mains supply voltage corresponds to
the voltage printed on the type plate on the
rear panel of the TV. If the mains voltage is dif-
ferent, consult your dealer.
LASER
Type
Wave length
Output Power
Beam divergence
Important
This apparatus is fitted with an approved mould-
ed 13 Amp plug.
To change a fuse in this type of plug proceed as
follows :
1. Remove fuse cover and fuse.
2. Fit new fuse which should be a BS1362 5A,
A.S.T.A. or BSI approved type.
3. Refit the fuse cover.
In order to maintain conformity to the EMC
directive, the mains plug on this product must
not be removed.
Connecting the aerial
The aerial should be connected to the socket
marked x at the back of the set. An inferior aer-
ial is likely to result in a poor, perhaps unstable
picture with ghost images and lack of contrast.
Make-shift or set-top aerials are unlikely to give
adequate results.
Your dealer will know from experience the most
suitable type for your locality.
Should you wish to use the set in conjunction
with other equipment, which connects to the
aerial socket such as TV games, or a video cam-
era, it is recommended that you consult your
dealer on the best method of connection.
Stand (if provided)
Use only the stand provided with the set, mak-
ing sure that the fixings are properly tightened. A
diagram showing how to assemble the stand is
packed with the stand. Never use a make-shift
stand, or legs fixed with woodscrews.
Semiconductor laser InGaAIP
650 nm (DVD)
790 nm (VCD/CD)
7 mW (DVD)
5 mW (VCD/CD)
DVD: Parallel: 8 degree
Perpendicular: 28 degree
CD: Parallel: 11 degree
Perpendicular: 35 degree