Table of Contents
Advertisement
ENGLIS
17
e Use two 3V CR123A lithium batteries.
6 The camera will not operate unless the batteries are
correctly loaded.
e Change the two batteries at the same time and always
use new batteries. Do not mix new and old ones.
3. Check the batteries (Fig. 3)
While pressing in the Dial Lock Release, turn the Select-
ing Dial from OFF to "P" (or "A" or "М"). If the Lens moves
out into shooting position, the batteries are loaded cor-
rectly.
4. Condition of batteries (Fig. 4)
* Indicator lights (Fig. 4-A)
* Indicator lights (Fig. 4-B)
*
Indicator flickers (Fig. 4-C)
1; The battery capacity is normal.
2) The battery capacity is low. Replace the batteries with
new ones,
(3) Since the battery capacity is low, the shutter lock is
applied. Replace the batteries with new ones.
e A pair of new batteries will provide power for taking
about 3000 shots without flash, and about 600 shots
when half of the pictures are taken with flash (as tested
according to Fujifilm's battery testing procedure).
Two CR123A lithium batteries; about 3000 shots can be
taken without flash, and about 600 shots with 50% flash
(as tested according to Fujifilm's battery testing proce-
dure).
e Dimensions
166 (W) х 110 (H) = 66 (D) mm. [166 (W) x 110 (H) א
70 (D) mm] (Dimensions when the lens barrel is re-
tracted)
e Weight
815 g [835 g] (without batteries).
e Accessories
Camera soft case, neck strap, lens hood, soft case for
lens hood, lens cap, batteries (two).
* Specifications and performance are subject to change
without notice.
I. READYING THE CAMERA
LOADING THE BATTERIES
1. Open the battery compartment cover (Fig. 1)
Set the Selecting Dial to OFF and, with a coin, turn the
Battery Compartment Cover Screw toward the arrow to
open the Cover.
2. Insert the batteries (Fig. 2)
Insert the batteries in the Battery Compartment with the
plus (+) and minus (—) ends correctly as illustrated inside
the Cover, then close it by tightening it with a coin.
Advertisement
Table of Contents
