Philips 32PW8907 Manual page 13

2150.2 gb (16X24) RC2
Surround Modes
Dependent on the sound signal broadcasted, select
one of the Surround modes.
Stereo
This mode reproduces only the
left and right front sound signals.
You only hear a stereo sound if
the broadcast which you are
receiving is transmitted in stereo
or nicam stereo.
Dolby 3 Stereo (optimal with Dolby Surround
broadcasting)
The sound signal is now
distributed over the front left,
the front right and the centre TV
loudspeakers.
The rear loudspeakers do not
produce any signal.
3D Surround (optimal with Dolby Surround
broadcasting)
3D Surround enables you to
experience the effect of Dolby
Surround Pro Logic * without
the need of having rear speakers
connected or activated.The
graphical representation of the
rear loudspeakers is replaced by the symbol ®r.
Select the level of 3D effect with the cursor
left/right.
*
'Dolby' 'Pro Logic' and the double-D symbol
of Dolby Laboratories Licensing Corporation.
Manufactured under license from Dolby Laboratories Licensing
Corporation.
26-06-2002 10:47 Pagina 13
With two extra front loudspeakers connected
To enhance the sound reproduction of your TV you
may connect two extra front loudspeakers via an
external amplifier. See Connect Peripheral Equipment,
Extra loudspeakers/Amplifier, p. 29.
In the Surround modes + ext. amp is added to
indicate that you should switch on your amplifier as in
these modes the internal TV speakers only produce
centre sound.The subwoofer speaker is muted.
Note: If extra front speakers are connected and selected,
G
are trademarks
Hall
The special sound signal is
distributed over the rear
loudspeakers which creates
a hall effect from the rear.
The centre loudspeaker
does not reproduce any
signal.
This mode is recommended when you wish to
add surround sound to a broadcast which is not
encoded in Dolby Surround or which has a
mono signal.
Pro Logic (with Dolby Surround broadcasting)
In addition to the left and
right internal speakers, the
centre and the rear
surround loudspeakers
reproduce the Dolby
Surround Pro Logic
sounds.
This sound is always present in the movie or
programme marked with G Dolby
Surround*.This mode is especially recommended
for such programmes or movies.
Dolby Surround Pro Logic signals are also
present on some DVD tracks.
Note: Normal stereo broadcast is not always
encoded to produce a rear surround sound.
In case of a Cinema Link configuration connected,
the surround modes of the receiver can be
selected.
Pro Logic and Hall can only be reproduced if
Surround speakers is set to Yes in the Setup,
Speakers menu, p. 9, and rear speakers are
connected.
all internal TV speakers produce centre sound in the
surround modes Pro Logic*, Dolby 3 Stereo and 3D
Surround.
Use of the menus
13