Cables And Modules - Nvidia ConnectX-4 Lx User Manual

4. Applying even pressure on four corners of the card (as shown in the below picture), insert the
adapter card into the PCI Express slot until firmly seated.
5. Secure the adapter with the adapter clips or screws.
6. Close the system case.

To uninstall the adapter card, see

Cables and Modules

Cable Installation
1. All cables can be inserted or removed with the unit powered on.
2. To insert a cable, press the connector into the port receptacle until the connector is firmly
seated.
a. Support the weight of the cable before connecting the cable to the adapter card. Do
this by using a cable holder or tying the cable to the rack.
b. Determine the correct orientation of the connector to the card before inserting the
connector. Do not try and insert the connector upside down. This may damage the
adapter card.
c. Insert the connector into the adapter card. Be careful to insert the connector straight
into the cage. Do not apply any torque, up or down, to the connector cage in the
adapter card.
d. Make sure that the connector locks in place.

When installing cables make sure that the latches engage.

Always install and remove cables by pushing or pulling the cable and
connector in a straight line with the card.
3. After inserting a cable into a port, the Green LED indicator will light when the physical
connection is established (that is, when the unit is powered on and a cable is plugged into
Uninstalling the Card.
19