Cables And Modules; Identifying The Card In Your System - Nvidia 900-9X662-00 53-ST1 User Manual

4. Holding the adapter card from its center, gently pull the ConnectX-6 Lx out of the PCI Express
slot.

To uninstall the adapter card, see

Cables and Modules

Cable Installation
1. All cables can be inserted or removed with the unit powered on.
2. To insert a cable, press the connector into the port receptacle until the connector is firmly
seated.
a. Support the weight of the cable before connecting the cable to the adapter card. Do
this by using a cable holder or tying the cable to the rack.
b. Determine the correct orientation of the connector to the card before inserting the
connector. Do not try and insert the connector upside down. This may damage the
adapter card.
c. Insert the connector into the adapter card. Be careful to insert the connector straight
into the cage. Do not apply any torque, up or down, to the connector cage in the
adapter card.
d. Make sure that the connector locks in place.

When installing cables make sure that the latches engage.

Always install and remove cables by pushing or pulling the cable and
connector in a straight line with the card.
3. After inserting a cable into a port, the Green LED indicator will light when the physical
connection is established (that is, when the unit is powered on and a cable is plugged into
the port with the other end of the connector plugged into a functioning port). See
Interface under the Interfaces section.
4. After plugging in a cable, lock the connector using the latching mechanism particular to the
cable vendor. When data is being transferred the Green LED will blink. See
Interface under the Interfaces section.
5. Care should be taken as not to impede the air exhaust flow through the ventilation holes. Use
cable lengths which allow for routing horizontally around to the side of the chassis before
bending upward or downward in the rack.
6. To remove a cable, disengage the locks and slowly pull the connector away from the port
receptacle. LED indicator will turn off when the cable is unseated.

Identifying the Card in Your System

On Linux
Uninstalling the Card.
LED
LED
17