Operation - Onkyo DX-C311 Instruction Manual

Connecting Onkyo Components for RI
Operation
When connecting Onkyo products, it is
necessary to attach the FRI cable to be able
to use the remote control of the amplifier
(or receiver) to control the entire system.
1. To use this CD player with an amplifier
(or receiver), cassette tape deck and
tuner with the FRI mark, insert the
remote control cable plugs into the
REMOTE CONTROL jacks as shown.
As the exact connection sequence of the
fRI cable is unimportant, you can
connect from the amplifier (or receiver)
to either the tuner, the cassette tape
deck or to the compact disc player.
To operate correctly the remote control
must face towards the remote control
sensor of the amplifier or receiver.
NOTE:
¢ The upper and lower fRI remote
control jacks have the same function.
* Remote control operation is not
possible when only the remote control
cable is connected — the audio
connection cables must also be
connected.
¢ An fRI remote control cable equipped
with a 1/8" (3.5mm) diameter miniature
two-conductor phone plug is included
with the DX-C311/C211/C111 and with
every tuner and compact disc player
with the (RI mark.
Ol: Op
You can use the following buttons to
control your amplifier or receiver.
Pl : Stop button
il : Pause button
— : Play button
be Ret <iq : Down button
> p : Up button
1~9, 0, +10
eae
:
Alternatively, you can use a remote control
MEMORY that has been provided with an Onkyo unit
such as the A-911. If this is the case, the
~ : Open/close button
L ~+-~<q : Fast reverse button
oy > p- : Fast forward button
REMOTE CONTAOL TRANSMITTER AC-289S
1-9, 0, +10 : Number buttons
MEMORY : Memory button
CLEAR _— : Clear button
The illustration on the left shows the
remote control provided with the Onkyo A-
911 amplifier. The remote control you use
may be different to the one shown.
15