Daily Use - Hoover H-WASH 700 User Manual

9. DAILY USE

This device can automatically adjust the
level of water to the amount and type of
laundry. With this
consumption is reduced and washing times
are considerably shortened.
WARNING:
touching the display in the first few
seconds after you have plugged in the
appliance could interrupt its self-
calibration procedure, thus jeopardising
the appliance's proper functioning. In
this case, take out the plug and repeat
the operation.
Quick guide
Please read the wash cycle table and
carry out all steps in the order set out
in the instructions.
l
Switch the device
ON/OFF.
l
Swipe left or right on the screen or press
the arrows on the screen to display the
available programmes.
l
Select the required
pressing on the corresponding icon.
l
You can change the programme settings
(e.g. temperature and spin speed) by
selecting the specific icon and swiping
along the ring dial.
l
Select the options you want among the
available ones after selecting the
icon.
l
Press START to start the programme.
l
Switch off the device at the end of the
cycle by pressing ON/OFF for at least 3
seconds.
system, energy
on by pressing
programme by
21
Should there be a power cut when the
device is running, a special memory
feature saves the settings and, when
power returns, the appliance resumes
the cycle from where it left off.
Technical data
Water pressure:
min 0.05 Mpa / max 0.8 Mpa
(0.05 MPa dispenses approximately 1 litre
of water in 10 seconds)
Spin r.p.m.: See rating plate.
Power input / Power current fuse amp /
Supply voltage: See rating plate.
Start programme
Close the door BEFORE pressing
START.
l
To start the cycle with the selected
settings, press START. When the cycle
has started, the time remaining until the
end of the cycle will be displayed.
l
If you want to modify the selected
programme, select
require, change the default settings and
then press START to begin the cycle.
Only options compatible with the
programme you have chosen can be
selected.
l
After switching on the appliance, wait a
few seconds for the programme to start
running.
PROGRAMME DURATION
l
When selecting
duration of the cycle will be automatically
shown; this time may vary depending on
the options you select.
l
After starting the programme, the display
will keep you constantly updated on the
time remaining until the end of the wash
cycle.
the options you
a programme, the