Installation - AOC AGON PD49 User Manual

Installation

Do not place the monitor on an unstable cart, stand, tripod, bracket, or table. If the monitor falls, it can injure a person and cause
serious damage to this product. Use only a cart, stand, tripod, bracket, or table recommended by the manufacturer or sold with this
product. Follow the manufacturer's instructions when installing the product and use mounting accessories recommended by the
manufacturer. A product and cart combination should be moved with care.
Never push any object into the slot on the monitor cabinet. It could damage circuit parts causing a fire or electric shock. Never spill
liquids on the monitor.
Do not place the front of the product on the floor.
If you mount the monitor on a wall or shelf, use a mounting kit approved by the manufacturer and follow the kit instructions.
WARNING: SUPPLY LINES! DANGER TO LIFE BY ELECTRIC SHOCK!
Take appropriate measures to avoid damaging supply lines (electric, gas, water) during wall mounting.
Leave some space around the monitor as shown below. Otherwise, air-circulation may be inadequate hence overheating may
cause a fire or damage to the monitor.
To avoid potential damage, for example the panel peeling from the bezel, ensure that the monitor does not tilt downward by more
than -5 degrees. If the -5 degree downward tilt angle maximum is exceeded, the monitor damage will not be covered under warranty.
See below the recommended ventilation areas around the monitor when the monitor is installed on the wall or on the stand:
Installed with stand
Installed with stand
4 inches
10cm
12 inches
30cm
4 inches
10cm
Leave at least this much
space around the set
3
4 inches
10cm