Installation - AOC Q27G4N User Manual

Installation

Do not place the monitor on an unstable cart, stand, tripod, bracket, or table. If the monitor falls, it can
injure a person and cause serious damage to this product. Use only a cart, stand, tripod, bracket, or table
recommended by the manufacturer or sold with this product. Follow the manufacturer's instructions when
installing the product and use mounting accessories recommended by the manufacturer. A product and cart
combination should be moved with care.
Never push any object into the slot on the monitor cabinet. It could damage circuit parts causing a fire or
electric shock. Never spill liquids on the monitor.
Do not place the front of the product on the floor.
If you mount the monitor on a wall or shelf, use a mounting kit approved by the manufacturer and follow
the kit instructions.
Leave some space around the monitor as shown below. Otherwise, air-circulation may be inadequate
hence overheating may cause a fire or damage to the monitor.
To avoid potential damage, for example the panel peeling from the bezel, ensure that the monitor does
not tilt downward by more than -5 degrees. If the -5 degree downward tilt angle maximum is exceeded, the
monitor damage will not be covered under warranty.
See below the recommended ventilation areas around the monitor when the monitor is installed on the wall
or on the stand:
Installed with stand
Installed with stand
4 inches
10cm
12 inches
30cm
4 inches
10cm
Leave at least this
much space around
the set
3
4 inches
10cm