Table of Contents
Advertisement
Operation
1. Connect the A and B inputs to the bridge or splitter as shown in one of the above diagrams (depending on the
equipment you have available). Set the source power to dBm and frequency to the test frequency.
-2, Connect a short circuit to the test port as the calibration standard. Press [PRESET] to return the HP 8508A to a
known state. Select [REFL MEAS] rho, angle to measure reflection coefficient.
c. Other functions
Choose LOAD with the following test setup.
Source
HP8&508A
908A
a Termination
Power
:
Splitter
908A Termination
(Calibration)
Device Under
Test
Probe Tee
Figure 3-14, Probe Inputs
3-18
ee
@ae
nu
un
nn
@w
Advertisement
Table of Contents
