IBM SummaSketch II Plus User Manual page 10

A Word About
Software
Installing the
SummaSketch
5
For the tablet to act as an input device,
your application must include a driver for the
tablet model you are using. The driver
allows your tablet and the application to
communicate with each other. It converts the
tablet output into information that the application
can understand and use. Most programs have
Summagraphics drivers built right in. (To be
sure, refer to the software manual or contact the
software manufacturer.) Below is a listing of
drivers required by the SummaSketch II Plus
tablets. If you are using a
SummaSketch II Plus (or SummaSketch
II Professional Plus) with a four-button
cursor or stylus, you must select the
SummaSketch (or MM series) driver
within the application.
SummaSketch II Plus (or SummaSketch II
Professional Plus) with a 16-button cursor,
you must select the Microgrid (or UIOF)
driver within the application.
Below are the steps to installing your
SummaSketch.
1.
Plug the cursor or stylus into the
top right socket.
The cursor and stylus are interchange-
able. However, when changing from
one to the other, tum off the tablet.
(This allows the tablet's internal
firmware to fine tune for each device.)