Kenwood 107VR Instruction Manual page 22

2
PRO LOGIC
Nan
ow
3 | Set the sub-woofer.
@ Press the SETUP key (remote control unit
only}.
UB ON SETUP
"s "or
"SUB OFF" is CA
displaved CA
_—. © Set the sub-woofer to ON or OFF.
© Press the SETUP key to set the selection.
When the selection is set, the unit enters
the condition for "G Adjust the front
speaker balance".
Adjust the front speaker balance.
@ Ensure that the balance setup is dis-
played.
@ Adjust the front speaker (left & right)
levels so that the left and right levels are
identical.
: To aecrease the =
. oe
ieft cnanne. sourd
tC
)
a LEVEL >
— CONTROL
right channel sound <7 oe
© Press the SETUP key again to establish
the setup.
After this, the unit enters the condition
for "G Adjust the volume level of each
speaker".
207VR [Er
OO
(CXeKs)}
Keys ot controls to De used ir tris operation
The input sources are switched tn the following order
1 NORMAL When the center speaker 1s a compact
speaker
2 WIDEBAND : When the center speaker is a large speaker
3. PHANTOM = When no center speaker is used
2 Setting the sub-wooter
@ Adjusting the front speaker balance
G Adjusting the delay time
End of setup
To cancel setup in the middle, press the SETUP key repeatedly until the
setup mode 1s cancelled
Each press switches the sub-woofer as follows
c 1 SUBON Sub-woofer ON
2 SUB OFF : Sub-woofer OFF
Left soeaker
Center position
Right speaker
POs.tlon Indication position
~ + SURROUND | -_
Balance setup.